Filter
Top Products
10
28
18
9. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
H
andrail with a #8 x 1/2" Ground Screw (11).
C
onnect the wire harness on the Console Base
(26) to the Upright Wire (28). See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
11
2
6
Ground
Wire
28
Wire
H
arness
9
22
10. Insert the wires into the Console Base (26) as
you set the Console Base on the Handrails. Be
careful not to pinch the wires. Next, thread
two 1/4" x 1/2" Bolts (22) with 1/4" Star Washers
(21) into the Handrails and the Console Base;
do not tighten the Bolts yet.
Attach the Console Base (26) to the Handrails
(18) with four #8 x 3/4" Screws (2). Then,
tighten the two 1/4" x 1/2" Bolts (22).
2
22
21
21
2
18
18
10
26
Front View
11. Lower the Uprights (31, 36).
See the inset drawing. Position the Uprights
(31, 36) so that the Frame (74) is centered be-
tween the Uprights.
Firmly tighten the 3/8" x 3" Bolts (32) and then
the 3/8" x 2 1/4" Bolts (40) on each side of the
treadmill. Do not overtighten the 3/8" x 3"
Bolts.
36
31, 36
32
74
74
31
View from Above
Side View
11
40