Gold's Gym CWTL05607 Treadmill User Manual


 
10
1. Remove the key from the console and unplug
the power cord.
Remove the indicated #8 x 3/4" Screw (3) and
the Access Door (76) from the back of the
Console Base (85).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base
(85).
Hold the receiver so that the small cylin-
der is oriented as shown and is facing the
Console Base. Attach the receiver to the plastic
posts on the Access Door (76) with the two in
-
cluded small screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (76) with the #8 x 3/4" Screw
(3). Discard the other wires included with the re-
ceiver.
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver
included with the chest pulse sensor.
A
85
Small
Cylinder
3
76
Wire
Small
Screws
10. Attach the Latch Housing (73) to the Left Upright
(84) with two #8 x 3/4" Screws (3); start both
S
crews and then tighten them. Note: Make
sure that the large hole in the Latch Housing
i
s on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (73). Then, tighten the knob onto the
pin.
10
3
Pin
Spring
Collar
Knob
73
11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 26 and 27).
84
Large
Hole