Filter
Top Products
14
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
c
old temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
d
o this, the console displays or other electrical
components may become damaged.
Plug in the power cord (see
page 12). Next, locate the
reset/off circuit breaker on
the treadmill frame near the
power cord. Switch the cir-
cuit breaker to the reset po-
sition.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and switch the circuit
breaker to the reset position, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds. If the displays
remain lit, see THE INFORMATION MODE on page
20 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing on page 13)
and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment,
the displays will light. IMPORTANT: In an emergency
situation, the key can be pulled from the console,
causing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if the
key is not pulled from the console, adjust the posi-
tion of the clip.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2. Enter your weight if desired.
For the most accurate
calorie count, enter your
weight into the console by
repeatedly pressing the
increase and decrease
buttons next to the dis-
play. Note: Once you have entered your weight,
your weight will be saved in memory.
3. Select the manual mode.
When the key
i
s inserted,
the manual
m
ode will be
selected. If
you have se-
lected a work-
out, press any of the workout buttons repeatedly
until a track appears in the display.
4. Start the walking belt.
To start the walking belt, press the Start button, the
Speed increase button, or one of the numbered
Precision Quick Speed buttons.
If you press the Start but-
ton or the Speed in-
crease button, the walk-
ing belt will begin to move
at 1 mph. As you exer-
cise, change the speed
of the walking belt as desired by pressing the
Speed increase and decrease buttons. Each time
you press a button, the speed setting will change
by 0.1 mph; if you hold down a button, the speed
setting will change in increments of 0.5 mph.
If you press one of the numbered speed buttons,
the walking belt will gradually change speed until it
reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To restart
the walking belt, press the Start button, the Speed
increase button, or one of the numbered speed
buttons.
5. Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons or one of
the numbered Quick
Incline buttons. Each time
you press the Incline increase or decrease button,
the incline will change by 0.5%. If you press one of
the numbered Quick Incline buttons, the treadmill
will adjust to the selected incline setting. Note:
After you press the buttons, it may take a moment
for the treadmill to reach the selected incline set-
ting.
Track
Reset
Position