Filter
Top Products
11
12. The Console (5) requires four 1.5V “D” batteries
(not included); alkaline batteries are recom-
mended. IMPORTANT: If the elliptical exercis-
er has been exposed to cold temperatures,
allow it to warm to room temperature before
inserting batteries into the Console. If you
do not do this, the console displays or other
electronic components may become dam-
aged. See the inset drawing. Remove the bat-
tery cover from the Console and insert four bat-
teries into the Console. Make sure that the bat-
teries are oriented as shown by the diagram in
the battery compartment. Then, reattach the bat-
tery cover.
Note: The Console (5) can be operated with an
optional power supply instead of batteries. To
purchase a power supply, call the telephone
number on the front cover of this manual.
Plug one end of the power supply into the jack
on the console. Plug the other end of the power
supply into an appropriate outlet that is properly
installed in accordance with all local codes and
ordinances.
Have a second person hold the Console (5) near
the Upright (6) as shown. Connect the console
wire to the Wire Harness (48). Insert the excess
wire downward into the Upright.
Attach the Console (5) to the Upright (6) with
four M4 x 16mm Self-tapping Screws (79).
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
12
5
5
Batteries
Battery
Cover
Console
Wire
48
6
79