Filter
Top Products
FT94
-20-
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under the
treadmills warranty.
PROBLEM SOLUTION/CAUSE
Display does not light Tether cord not in position.
Circuit breaker on front grill tripped. Push circuit breaker in until
it locks.
Plug is disconnected. Make sure plug is firmly pushed into
AC household wall outlet.
Household circuit breaker may be tripped.
Treadmill defect. Contact your FUEL dealer.
Treadbelt does not stay centered
Treadmill belt hesitates when walked/run on A user may be walking while favoring or
putting more weight on either the left or right
foot. If this walking pattern is natural, track the
belt slightly off-center to the side opposite from
the belt movement. See General Maintenance
section on Treadbelt Tension. Adjust as
necessary.
Motor is not responsive / Display is lit Make certain clock is running.
Treadmill will only achieve approximately
7 mph but shows higher speed on display This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required
it should be as short as possible and heavy
duty 16 gauge minimum. Low household
voltage. Contact an electrician or your FUEL
dealer. A minimum of 110 volt AC current is
required.
Treadbelt stops quickly/suddenly when High belt/deck friction. See General Maintenance
tether cord is pulled section on lubrication.
Treadmill trips on board 15 amp circuit High belt/deck friction. See General Maintenance
Computer shuts off when console is
touched (on a cold day) while walking/running Treadmill is not grounded. Static electricity is crashing the
computer. Refer to Grounding Instructions on
page 4.
Service Checklist - Diagnosis Guide