Freestyle FS 1064 Watch User Manual


  Open as PDF
of 16
 
Freestyle- Gromatide Instruction
30/01/2010
FS 1064 Gromatide AG7027-INST-R01
2741
AG7027
27/01/2010
itenumberistheoneforthecurrent
location.
3. PressS1buttonorS2buttontomove
forwardorbackwardrespectivelythe
favoritenumberandthereforethecorre-
spondinglocationnametobeselected.
4. PressS3button,thegeographicalRE-
GIONwillblink.
5. PressS1buttonorS2buttontomove
forwardorbackwardrespectivelythe
REGIONtobeselected.
6. PressS3button,thegeographicalLOCA
TIONwillblink.
7. PressS1buttonorS2buttontomove
forwardorbackwardrespectivelythe
LOCATIONtobeselected.
8. PressS3button,theDST(daylightsav-
ingstime)statuswillblink.
9. PressS1buttonorS2buttontomove
forwardorbackwardrespectivelythe
DSTstatustobeselected.IfAUTOisse-
lected,thewatchshalldeterminewhen
thelocationisonDST;
ifOFForONisselected,theDSTstatus
isforcedtotheselectedstatusallthe
time.PleasenotethatthecurrentDST
statusisshownwiththeDSTag.
10.PressS3button,thecustomlocation
selectionwillblink.
11.PressS1orS2buttontotogglebetween
YESandNO.IfNOisselected,thatstep
istheendofthesettingsequence.Oth-
erwise,thesequencecontinuestoallow
settingthetimeoffsettothetidedata
andthe16charactersofthecustom
locationname.
12.PressS3button,thetimeoffset(inthe
unitofminutes)tothetidedataforthe
customlocationwillblink.
13.PressS1buttonorS2buttontoincrease
ordecreaserespectivelythetimeoffset
(theavailableoffsetsare-180,-170,…,
-10,0,+10,…,+170,+180minutes).The
offsethasnoimpactontheDSTstatus.
14.PressS3button,therstcharacterof
the16-charactercustomlocationname
willblink.
15.PressS1buttonorS2buttontocycle
forwardorbackwardrespectivelythe
selectedcharacter.PressS3buttonto
proceedtothenextcharacter.
16.Afternishedmakingallthesettings,
pressS4buttontoconrmthesettings.
TO USE THE CHRONOGRAPH
Forthemeasurementofelapsedtime,
1.PressS3buttontoselectCHRONO
GRAPHmode.
2.PressS1buttontostartcounting.
3.Tostopcounting,pressS2button.Press
S1buttontoresumefromwhereitleft
off.
4.Toresettozero,pressS2buttononce
tostopcountingandthenpressS2but-
tonagain.
NOTE:Forthersthour,theCHRONOtime
isdisplayedintheMM.SShh(minutes.
secondhundredths)format.Afteronehour,
theCHRONOtimeisdisplayedinHH:MM
SS(hours:minutes.seconds)format.
NOTE:TheCHRONOcancountup
toamaximumtimeof99:59.59
(99hours:59minutes.59seconds).
TO SET THE TIMER
1. PressS3buttontoselectTIMERmode.
2. PressS4button,the“SET”message
appearsandtheHourdigitsblinkonthe
display.
3. PressS1buttontoincreasethedigitsby
oneunit,orpressS2buttontodecrease
thedigitsbyoneunit.Holdingdown
eitherbuttonwillspeeduptheprocess.
4. PressS3buttononce,theMinutedigits
willblinkonthedisplay.
5. PressS1buttonorS2buttontosetthe
Minutedigits.
6. PressS3buttononce,theSeconddigits
willblinkonthedisplay.
7. PressS1buttonorS2buttontosetthe
Seconddigits.
8. PressS3buttononce,theactiontobe
takenattheendofacountdownwill
blink.
9. PressS1buttonorS2buttontotoggle
betweenSTOPandREPEAT.IfSTOPis
selected,theTIMERstops;ifREPEATis
selected,theTIMERrepastsitscount
downfor99times.
10.Afternishedmakingallthesettings,
pressS4buttontoconrmthesettings.
NOTE:TheTIMERcancountup
toamaximumtimeof23:59.99
(23hours:59minutes.59seconds).
TO USE THE TIMER
1.PressS3buttontoselectTIMERmode.
2.PressS1buttontostartacountdown.
3.Tostopcounting,pressS2buttononce.
PressS1buttontoresumefromwhereit
leftoff.
4.ToresettheTIMER,pressS2buttononce
tostopcountingandthenpressS2but-
tonagain.
5.Uponcompletionofacountdown,if
STOPisselectedastheactiontobe
taken,theTIMERstopsatzero,atune
willbeemittedandthebacklightwill
ash;ifREPEATisselected,theTIMER
repeatsitscountdownwiththerep
numberupdated.IftheTIMERreset
timeislessthan30seconds,abeepwill
beemitted.Otherwise,atunewillbe
emittedandthebacklightwillash.
TO SET THE HEAT TIMER
1.PressS3buttontoselectHEATTIMER
mode.
2.PressS4button,the“SET”message
appearsandtheMinutedigitsblinkon
thedisplay.
3.PressS1buttontoincreasethedigits
byveunits,orpressS2buttonto
decreasethedigitsbyveunits.Holding
downeitherbuttonwillspeedupthe
process.
4.Afternishedmakingallthesettings,
pressS4buttontoconrmthesettings.
NOTE:TheHEATTIMERcancountuptoa
maximumtimeof35.00(35minutes).
TO USE THE HEAT TIMER
1.PressS3buttontoselectHEATTIMER
mode.
2.PressS1buttontostartacountdown.
3.Tostopcounting,pressS2buttononce.
PressS1buttontoresumefromwhereit
leftoff.
4.ToresettheHEATTIMER,pressS2but-
tononcetostopcountingandthenpress
S2buttonagain.
5.Uponcompletionofacountdown,atune
willbeemittedandthebacklightwill
ash.
NOTE:TheHEATTIMERisindependent
oftheTIMER.Bothmayberunningatthe
sametime.
TO SET THE ALARM TIME
1. PressS3buttontoselectALARMmode.
2. PressS4button,the“SET”messageap
pearsandthealarmentrytosetblinks
onthedisplay.
3. PressS1buttonorS2buttontotoggle
betweenALARM1andALARM2.
4. PressS3button,theHourdigits(includ
ingAM/PMfor12-hourformat)will
blink.
5. PressS1buttontoincreasethedigitsby
oneunit,orpressS2buttontodecrease
thedigitsbyoneunit.Holdingdown
eitherbuttonwillspeeduptheprocess.
6. PressS3button,theMinutedigitswill
blink.
7. PressS1buttonorS2buttontosetthe
Minutedigits.
8. PressS3button,thealarmfrequency
willblink.
9. PressS1buttonorS2buttontocycle
forwardorbackwardrespectivelythe
alarmfrequencytobeselected(DAILY,
WEKDAYS,WEEKENDS,dayofthe
weekandWKLY).
10.Afternishedmakingallthesettings,
pressS4buttontoconrmthesettings.
NOTE:TheALARMTIMEdisplayedisinthe
sameTimeFormatastheprimarytime.
NOTE:Atunewillgooffandthebacklight
willashfor20secondsatthedesignated
timewhentheALARMisactivated.
NOTE:Thealarmwillautomaticallybe
activatedafterbeingset.
WHEN AN ALARM OR HOURLY CHIME
GOES OFF
AtunewillgooffbythehouriftheHourly
Chimefunctionisactivatedandthesame
willhappenatthedesignatedtimewhen
theALARMisactivated.Tostopthetune,
pressanybutton.
Ifthealarmtuneisdonewithoutanyuser
interruption,thewatchwillautomatically
enterasnoozemode.TheALARMwillgo
offagainafter5minutesbutforonlyonce.
TO USE THE BACKLIGHT
PressS5buttontoturnonthebacklightfor
threeseconds.
Toreducecarbonfootprint,these
Freestyleinstructionsareprintedwith
soyinksonrecycledpaper.
ENGLISH ENGLISH
FS1064-GROMATIDE-AG7027-R01
 previous next