Your unit is powered by four AAA batteries. You
must install the batteries before you can use the
unit. The battery compartment is located on the
back of the unit at the top. Please have a small
Phillips screwdriver at hand before following the
steps below to install or change the batteries.
1. Turn the unit off (if necessary) and turn it over.
2. Unscrew the tiny screw at the bottom of the
battery compartment.
3. Using your thumbs, push the latches in and
lift the cover off.
4. Install four new AAA batteries following the
markings in the compartment.
5. Replace the battery cover and the screw.
6. Using a paper clip, gently press the Reset
button located on the back of the unit.
CAUTION:
TO AVOID BATTERY LEAKAGE…
• Be sure to insert the batteries correctly and always follow
the product and battery manufacturer's instructions;
• Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium)
batteries;
• Always remove weak or dead batteries from the product.
3
Getting Started
manualSCR-226Rev.B.qx 7/3/03 12:00 PM Page 3