Filter
Top Products
7
STEP 4 – Foot Platforms Assembly
a) Place the Metal Sleeves over the studs on Foot Tube. Place the longer (black) Sleeves on
center studs.
b) Slide the Foot Platform on the metal sleeves. To secure the Foot Platforms, line up holes and insert
front and rear 1/4” x 20mm Phillips Bolts and M6 Washers. Tighten with the Screwdriver provided.
Repeat on other side.
STEP 5 – Stationary Bar Assembly
Feed the Computer and Pulse Wires up
through the Stationary Bar Assembly. Slide
the Stationary Bar Assembly into the top of
the Vertical Column Tube. Attach with
the three M8 x 15mm Allen Bolts,
M8 Spring Washers and M8 Curved
Washers. Tighten with the long Allen
Wrench that is provided.
STEP 6 – Dual-Action Handlebars
Assembly
Insert Dual-Action Handlebars into the
corresponding Swing Arms. Secure using
four M8 Carriage Bolts, M8 Washers and
M8 Acorn Nuts. Tighten Bolts with the
Wrench provided.
Note: Curves on Handlebars should
face away from user when assembled
and pulse sensors should face towards user.
dual-action
handlebars
vertical
column
tube
swing arms
6
M8 carriage bolts,
M8 washers and
M8 acorn nuts
stationary bar
assembly
pulse
wires
computer
wire
vertical
column
tube
5
M8 x 15mm allen bolts,
M8 spring washers and
M8 curved washers
foot
platform
foot tube
1/4" x 20mm phillips bolts
and M6 washers
metal sleeves
foot tube
4a
4b