Filter
Top Products
4
4
• Lift the side tubes up and set the ends in the notch in each
base assembly.
Hint: The top of the net will flop forward.
• Slide a side tube, straight end first, through the sleeve on each
side of the net.
Sleeve
Side Tube
Sleeve
Side Tube
ASSEMBLY
ASSEMBLY
4
5
6
• Fit the upper end of the side tubes into the groove in each post.
Post
Grooves
Side Tubes
• Note the numbers on the base covers.
• Fit the base cover labeled
1
onto the base assembly labeled
1
.
Hint: Make sure the net is not under the base cover.
• Insert four #8 x
3
/
4
” screws into the base cover and tighten.
• Repeat this procedure to attach the other base cover labeled
2
to the base assembly labeled
2
.
7
1
Base Covers
2