Filter
Top Products
6 7
Controller Layout Playing Games
Start Up
With the batteries properly
installed and the IR and
converter units connected you
are ready to begin playing
with your 101-In-1 Action
Games Plug and Play. Make
sure that the Off/On switch on
the battery housing is set to
the ON position. Each player
should turn their individual
controller on. You will see the
system’s title screen come on
for a moment. You can skip
this screen by pressing the
start button on controller 1
(Black). You will then be taken
to the game selection screen.
NAVIGATING
THE GAME
SELECTION SCREEN
With either the controller’s
D-Pad or Joystick you may
scroll up and down the list of
games. You can also use left
and right to skip between the
several pages of games. Once
you have found the game that
you’d like to play, press start.
Within seconds the game’s
start-up screen will appear.
Note: Only Player 1 (Black
controller) can select games.
Directional Pad
(D-pad)
Joystick
A button
B button
Turbo
Buttons
Reset
Start
Reset
You can reset the system at any time with the reset button.
Turbo Buttons
These buttons act as the equivalent of pressing either the A or B
button rapidly.
Note: Each individual game uses the buttons and controls differently.
See instructions for each game for the function of buttons.
When the controllers are on you will see a light flash from the
center (just about the reset/start buttons). This indicates that the
controllers are powered and working.