Filter
Top Products
4
5
SET UP
101-In-1 Action Games Plug and Play
The Infrared (IR) receiver
should go on top of the TV so
that it receives a clear signal
from the controller units. Use
the stick pad on the bottom of
the receiver to stick it firmly in
place. Remove the protective
layer from the stick pad and
then press the receiver firmly
down onto your TV.
Take the RCA cables (these
are the white and yellow
plugs that are connected to
the IR) and plug them into
the corresponding slots on
the back (or sometimes front)
of your TV. Lay the battery
housing on a flat surface
and you have completed
connecting the 101-in-1
Action Games Plug and Play
system.
Quick Set Up:
1. Follow the instructions for installing batteries.
2. Remove stick pad from IR sensor and firmly press it to the top of your TV.
3. Connect the yellow and white RCA cables into the corresponding plugs on your TV.
4. Flip the switch on the battery housing to the ON position
5. Turn on the controller units and you are ready to play!
BATTERY INSTALLATION
Battery Housing
Carefully open the casing on
the battery housing. This is
done by using the tab on the
side of the unit. Once open,
install 4 AA batteries into the
unit, making sure to match
the polarity of each battery as
shown in the diagram inside
the battery compartment.
Once complete, firmly close
the battery compartment.
Controllers
Gently lay the controllers
face down. Underneath is the
battery compartment. With
a small Phillips head screw
driver, unscrew the battery
compartment housing. Insert 3
AA batteries (each controller),
making sure to match the
polarities as indicated on
the inside of the battery
compartment. Replace the
cover and screw on tightly.
Infrared
Receiver
Battery
Housing