Filter
Top Products
9
FCC REGULATIONS
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference that may cause
undesired operation.
NOTE:
This equipment has been test-
ed and found to comply with the limits
for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide reason-
able interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy, and if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation. If
this equipment does cause harm-
ful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
BATTERY SAFETY
• 2-AA batteries not included.
• Do not use rechargeable
batteries.
• Do not mix old and new
batteries.
• Do not mix alkaline, standard
or rechargeable batteries.
• Battery installation should be
done by an adult.
• Non-rechargeable batteries
are not to be recharged.
• Rechargeable batteries
should be removed from the
• Battery installation should be
done by an adult.
• Non-rechargeable batteries
are not to be recharged.
• Rechargeable batteries
should be removed from the
toy before being charged (if
removable).
• Rechargeable batteries
are only to be charged
under adult supervision (if
removable).
• Only install batteries of the
same type and polarity.
• Remove dead batteries from
the toy to prevent leakage.
• Do not short-circuit the
supply terminals.