Epic Fitness EPTL99609.0 Treadmill User Manual


 
17
5. Follow your progress with the displays.
The matrix—When you
s
elect the manual
mode, the matrix will
d
isplay a track that rep-
resents 1/4 mile (400
meters). As you exer-
cise, the indicators around the track will appear in
succession until the entire track appears. The track
will then disappear and the indicators will again
begin to appear in succession.
The Time/Incline dis-
play—The Time/Incline
display can show the
elapsed time. The dis-
play can also show the
incline of the treadmill
for several seconds each time the incline changes.
Press the Display button below the Time/Incline
display until the display shows the information that
you are most interested in viewing. Note: When a
workout is selected, the display will show the time
remaining in the workout instead of the elapsed
time.
The Calorie/Pulse dis-
play—The
Calorie/Pulse display
can show the approxi-
mate number of calories
you have burned. The
display will also show your heart rate when you
use the handgrip pulse sensor or the optional chest
pulse sensor.
The Distance/Speed
display—The
Distance/Speed display
will show the distance
that you have walked or
run and the speed of the
walking belt for a few seconds each. Press the
Display button below the Distance/Speed display
until the display shows the information that you are
most interested in viewing.
To reset the console, press the Start/Stop button,
remove the key, and then reinsert the key.
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
time, the console will not display your heart
rate accurately. See page 26 for information
about the optional chest pulse sensor.
Before using
t
he handgrip
pulse sensor,
remove the
sheets of clear
plastic from the
metal contacts.
In addition,
make sure that
your hands are
clean.
To measure your heart rate, stand on the foot
rails and hold the metal contacts on the handrail
for approximately ten seconds—avoid moving
your hands. When your pulse is detected, several
dashes will appear in the display and then your
heart rate will be shown. For the most accurate
heart rate reading, continue to hold the con-
tacts for about 15 seconds.
7. Turn on the fans if desired.
The fans feature high and low speed settings.
Press the Fans button repeatedly to select a fan
speed or to turn off the fans. Note: If the fans are
on when the walking belt is stopped, the fans will
turn off automatically after a few minutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Start/Stop but-
ton, and adjust the incline of the treadmill to the
lowest setting. The incline must be at the low-
est setting when you fold the treadmill to the
storage position, or you may damage the tread-
mill. Next, remove the key from the console and
put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts