Filter
Top Products
7. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill.
8
If you purchase the optional chest pulse sensor (see page
20), follow the steps below to install the re
-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screw (83) and the Access Door (58) from
the underside of the Console Back (85) on the left side.
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (85). Hold the re
-
ceiver so the small cylinder is oriented as shown.
Attach the receiver to the plastic posts on the Access
Door (58) with the two included small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (58) with the Screw (83). The other wires in-
cluded with the receiver may be discarded.
A
58
85
Small
Cylinder
83
Wire
Small
Screws
5. While pressing down on the Handrails (87), tighten eight
Upright Bolts (86) and four 3/8” Star Washers (88) into
t
he Uprights (90, 95) and the Handrail (87) as shown. B
e
careful to avoid pinching the Upright Wire Harness
(
108).
Note: The CD Holder (38) and the Cup Holder (43) are
replaceable. If these parts become dislodged from the
Console Base (80), simply press them back in.
5
87
95
38
43
88
86
90
8
6
86
88
8
0
6. Place the treadmill in the storage position (see HOW TO
FOLD THE TREADMILL FOR STORAGE on page 21).
Center the Frame (16) between the Uprights (90, 95).
Tighten the Upright Bolts (86) in the lower ends of the
Uprights.
90
6
95
16
86
86