Epic Fitness EPTL88105.0 Treadmill User Manual


 
9
8. Remove the elastic band holding the Upright Wire
Harness (75). Have two people hold the console assem-
bly near the Left Upright (73) and the Right Upright (74).
C
onnect the Upright Wire Harness to the console wire.
Make sure to connect the connectors properly (see
the inset drawing); the connectors should slide to-
gether easily and snap into place.
If the connectors do
n
ot slide together easily and snap into place, turn one
c
onnector and try again to connect them.
I
F THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Insert the Upright Wire Harness (75) and the console
wire into the Right Upright (74). Next, insert the brackets
on the console assembly into the Left Upright (73) and
the Right Upright.
Be careful not to pinch the wires.
74
Console
Assembly
Bracket
73
Console Wire
75
9. While pressing down on the Handrails (99), attach the
console assembly to the Uprights (73, 74) with four
Upright Bolts (72), four Washers (78), and four Star
Washers (71). Start all four Upright Bolts before tight-
ening them.
Note: The Left Accessory Tray (63) and the Right
Accessory Tray (64) are replaceable. If these parts be-
come dislodged from the console assembly, simply press
them back in.
9
8
75
Console
Assembly
72
64
78
71
78
73
99
99
63
71
74
Collar
Spring
99
Knob
Pin
10. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Next, insert
the pin into the hole in the side of the Handrail (99). Then,
tighten the knob back onto the pin.
10