Filter
Top Products
9
6. MATTRESS STORAGE
1. Lay the mattress on a flat surface, upside-down.
2. Roll-up the mattress starting from the head until you reach the foot of the mattress.
3. Use the straps at the end of the mattress and stretch them around the mattress to prevent it from
unraveling.
Note: Do not fold, crease or stack the mattresses.
7. MAINTENANCE
7.1 GENERAL
1. Check the main power cord and plug for abrasions or excess wear.
2. Check the mattress cover for signs of wear or damage.
3. Disconnect the air tube from the mattress. Then check the airflow coming from the two air outlets
on the pump. They should be alternately delivering air when the pump is set at “alternate” mode.
4. Check the air hoses for kinks or breaks. For replacement, please contact your local distributor.
6
4. Plug the power cord into a electrical outlet with the
appropriate voltage.
NOTE: The pump unit must be suitable for the
local power voltage.
NOTE: S’assure que la pompe est compatible
au voltage local ou disponible.
6. Turn the main power switch (on pump) to the ON
position. After you turn on power to the pump, you
will have to wait at least 20 minutes for the mattress
to become fully inflated.
The low pressure indicator (yellow LED) will
illuminate while the mattress is pressurizing.
When the appropriate pressure is reached, the Low
Pressure indicator (yellow LED) will go off and the
Normal Pressure indicator (green LED) will illuminate.
The bed is now ready for use.
NOTE: You can unplug the unit to power-off the device.
NOTE: L’appareil est également muni d’une fiehe de connexion à l’électricité.
CAUTION: The pump supplied with the mattress can only be used for mattresses recommended
by the manufacturer. Do not use it for any other purpose. (applied part: air mattress)
AVERTISSEMENT : La pompe ne peut être utilisée qu’avec le matelas designé ou r
recommandé par le manufactureier,. Ne pas server d’ysage autre que celui auquel
elle a été conçu
NOTE: (For models WITHOUT the low-air-loss function) During power outages, you can
cover the Quick Connector with the transport cap to maintain air pressure inside the
air cells.
NOTE: After installation, make sure any excess cord or tubing is removed from possible foot
traffic to avoid accidental tripping. All EQUIPMENT should be positioned to always
allow unhindered patient access by physicians and caregivers.
ON