Filter
Top Products
Aquatic Fitness System
2003 Owner’s Manual
Number of Filter Cycles:
Program the Number of Filter Cycles by pressing the PROGRAM
button a 4
th
time. Whenever you are programming a filtration setting,
the FILTER Icon will be displayed next to the word PROGRAM in the
LED Digital Display Window.
To adjust the number of filter cycles to run during a 24-hour period,
simply use the UP or DOWN Buttons to select the correct number.
Your choices are 1, 2, 3, or 4 cycles per day. The factory default is 2
times per day.
Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot
climates.
Temperature Unit:
Program the Temperature Unit by pressing the PROGRAM button
a 5
th
time. The current Temperature Unit will be visible in the LED
Digital Display Window.
To adjust the Temperature Unit used to measure spa water
temperature, simply use the UP or DOWN Buttons to select between
Fahrenheit (ºF) and Celsius (ºC). The factory default setting is
Fahrenheit.
Exit the Programming Sequence by pressing the PROGRAM Button a 6
th
time. All changes will be saved.
If you do not proceed with the programming within 60 seconds, the spa
will automatically exit the programming sequence and revert to your
previous settings. Any programming changes made up to that point
would be saved.
Heat Indicator Light
Heat Indicator Light:
This Light is illuminated whenever the heater is on. Additionally, the
HEAT Icon will also be displayed in the upper left corner of the LED
Digital Display Window.
Dimension One Spas Icon (Logo) Button
Dimension One Spas ICON (Logo): The time of day can be
viewed by pushing the Dimension One Spas ICON logo on the far
right of the control. If no other button is pushed within 5 seconds,
the display will revert to the spa water temperature reading.
The pre-set factory default is Fahrenheit. Using the PROGRAM
Button can change the clock.
22