Filter
Top Products
5) The water temperature displays after 1 min. then
it measures and displays the water temperature
every second. The water temperature range is
–5
0
C to 40
0
C. When it is out of range, it displays
[
0
C].
6) While pressing ࠗ
A
button you can confirm normal
time. When you release ࠗA button the watch
returns to the depth display after 1.5 secs.
Pressing ࠗ
C
button activates the lamp for a
maximum of 10 secs. The lamp switches off 1.5
secs after releasing ࠗ
C
button.
Cancelling diving mode
1) If you stay shallower than 1m (4ft) (depth display
“0.0m”) for more than 10 mins, the diving mode
will be cancelled automatically. After cancellation,
the next mode will be different depending on the
following diving conditions.
• While valid diving............Changes to the surface
mode (measuring the
resting time on the
surface)
• While invalid diving.........Changes to the time
and calendar mode or
surface mode in
continuation from the
previous time.
2) While the water sensor is dry, when you press M
button for more than 2 secs above a water depth
of 4m (15ft), the diving mode will be cancelled.
After cancellation, the mode will change
depending on the diving state as in “1”. However
if the water sensor gets wet, or is touched by a
finger, it is not possible to cancel.
L. Valid and invalid diving used in this watch
Valid diving: diving deeper than 1m(4ft) continuously
for more than 3mins. An example of 1 dive: (valid
diving)
One dive: In this watch, one dive starts from the time
you dive deeper than 1m (4ft) to the time
you return shallower than 1m (4ft) depth.
However when diving deeper than 1m (4ft) after
being shallower than 1m (4ft) for less than 10 mins,
the watch will record it as one continuous dive.
• An example of 1 dive: (valid diving)
• Display examples of valid and invalid diving for this
watch
M. The surface mode
[Measurement of reset time on surface]
This is a function which automatically measures the
elapsed time (resting time on the surface) after the
last valid dive
is completed. You can use it for
meeting a rest time criteria after completing a dive.
*1: Please look at L. [Valid and invalid diving used in
this watch]
In this mode
This is a mode that automatically measures the
elapsed time after a valid dive has been completed.
(Up to 24 hours)➔“SURF” mode display starts. After
24 hours has elapsed in “SURF” mode, the
measurement display automatically stops. This
mode will not appear again until the next valid dive
has been completed.
When a valid dive is complete, it will start timing
automatically. Minimum timing unit is one minute.
After Diving