Filter
Top Products
I. How to set the time and calendar
• To set the time from the time and calendar mode,
press ࠗ
B
button for more than 2 seconds, and the
“seconds” will start to flash.
• By pressing ࠗ
B
button you can make the figures
you wish to set flash.
• To set the flashing figures, press ࠗ
A button.
• If you set the calendar year correctly, you never
have to set the calendar again; neither at the
change over of the month or for leap years.
J. The alarm mode
Alarm mode: Once you have set the alarm, the
alarm will ring everyday at the same time like an
alarm clock. The alarm rings for 15 seconds.
:
1. Press ࠗ
M button to change to alarm mode.
2. Press ࠗB
button for more than 2 seconds to
change to the alarm hour setting mode
(hours will flash)
3. Make hour set with ࠗ
A
button.
4. Press ࠗ
B button once more to change to the
alarm minute setting mode (minutes will flash)
5. Make minute set with ࠗ
A
button.
6. Press either ࠗ
B or ࠗM button to complete the
alarm setting.
• Select alarm ON/OFF with ࠗ
A
button. By
pressing ࠗA button continuously, the alarm
monitor will ring.
• If you wish to stop the alarm while it’s ringing
press any button.
• While pressing ࠗ
C
button, the display will light
up. The display light will switch off about 1.5
seconds after releasing the ࠗ
C button.
K. The diving mode
Diving mode: [This function measures under water
depth]
• Whether in time and calendar mode, surface
mode, log mode or alarm mode, when the water
sensor is on, the watch is ready for diving mode.
• When the water sensor is ON, if the watch stays in
the ready for diving mode for more than 1 hour,
“CHEK” (D201/D207)/”ERR” (D202/D208) display
will appear in the dot display window.
If this happens, please wipe the water sensor dry,
and start diving after confirming “CHEK”
(D201/D207)/”ERR” (D202/D208) display has
disappeared.
When in the ready for diving state, if the pressure
sensor deflects water pressure of more than 1m
(4ft), the watch will change to the depth display
(diving mode).
1) When starting a dive, the dot display will tell the
swimming diver when the watch is in diving mode.
2) The LED will flash once every 4 seconds to show
the watch is dive mode.
3) The water depth is measured and displayed
every second. The range of water depth
measurement is 1.0m~ 80.0m (4~260ft). When
the watch is deeper than 80.0m (260ft), it displays
“---m” and when shallower than 1.0m (4ft), it
displays “0.0m”; thus the watch informs you when
it is outside its depth measurement range.
4) The diving time display measures and displays in
1 second units up to 29 mins., 59 secs. When it
passes the 30 min. mark, the display changes to
units of 1 min. With a maximum measuring time
of 199 mins. After that, the watch starts from 0
secs, again.
While Diving
Before Diving
Setting the alarm