Filter
Top Products
SETTINGS & TOOLS
G’zOne TYPE-S
129
G’zOne TYPE-S
128
2. Enter the four-digit lock code and press Center Select
Key for [OK].
NOTE
The default Lock Code is the last 4 digits of your mobile
telephone number.
3. Press Reset Default.
4. Press Center Select Key for [OK] after reading the
following warning message, the confirmation message
is displayed : Preference Settings Will be set to
factory defaults. Press Center Select Key for [OK]
to continue.
5. Press Navigation Key up or down to select Revert
and press Center Select Key for [OK].
A confirmation message is displayed briefly before the
phone resets itself.
6.5 System Select
Allows you to set your phone to search or roam for
another network when you are not in your home area.
Leave this setting as the default unless you want to alter
system selection as instructed by your service provider.
1. Press Center Select Key for [MENU], Navigation
Key right 2 times, Phone Settings,
System Select.
2. Press Navigation Key up or down to select one of
the following setting, then press Center Select Key
for [OK].
• Home Only: Only within your home area or home
affiliated area.
• Automatic: Scan the radio channels based on the
Automatic setting.
6.6 NAM Selection
To select the phone’s NAM (Number Assignment
Module) if the phone is registered with multiple service
providers:
1. Press Center Select Key for [MENU], Navigation
Key right 2 times, Phone Settings,
NAM Selection.
2. Press Navigation Key up or down to select one of
the following setting, then press Center Select Key
for [OK].
NAM1 / NAM2
A confirmation message is displayed briefly before the
phone resets itself.