Filter
Top Products
Acquiring GPS Position
Information Manually
You can use a button operation to
acquire GPS position information and
adjust your Home City (time zone), time,
and day settings in accordance with your
current location.
Note
●
GPS signal reception requires
large amounts of power.
Perform it only when necessary.
Getting ready
The receive operation is performed only
while the watch is in the Timekeeping
Mode (normal timekeeping).
●
Normally the mode hand points to the
current day of the week.
l Navigating Between Modes
30
Mode
hand
1. Move to a location appropriate for
signal reception and orient the watch
so its display is pointed straight up at
the sky.
2. Hold down (B) for at least three
seconds. Release the button as soon
as the second hand points to “T+P”.
●
The second hand will move in the
following sequence: “YES” or
“NO” n “T (TIME)” n “T+P”.
●
This indicates that position
information acquisition has
started.
30
Second hand
●
If position information acquisition
is successful, the second hand will
move to “YES” and then the watch
will automatically adjust its time
and day settings.
30
●
If position information acquisition
fails for some reason, the second
hand will move to “NO” and then
the watch will indicate the current
time and day without adjusting
them.
Note
●
Reception takes anywhere from
about 30 seconds to about two
minutes.
●
It can take as long as 13 minutes
when leap second information is
included.
●
You may experience location
information acquisition
problems when you are in the
vicinity of a time zone
borderline.
The watch’s time and day will
not be indicated correctly if the
Home City (Time Zone) setting
is not right for your location.
Perform position information
acquisition in a representative
city in your time zone or in a
location that is well within the
time zone. Or you can perform a
time information receive
operation to adjust time and day
settings after configuring Home
City (Time Zone) and summer
time settings manually.
l Selecting a Time Zone
l Acquiring GPS Time
Information Manually
Acquiring GPS Time Information
Manually
You can use a button operation on the
watch to receive GPS signal time
information. When the receive operation
is successful, the watch’s Home City
(time zone), day, and time settings will be
adjusted accordingly.
Note
●
GPS signal reception requires
large amounts of power.
Perform it only when necessary.
Getting ready
The receive operation is performed only
while the watch is in the Timekeeping
Mode (normal timekeeping).
●
Normally the mode hand points to the
current day of the week.
l Navigating Between Modes
30
Mode
hand
1. Move to a location appropriate for
signal reception and orient the watch
so its display is pointed straight up at
the sky.
2. Hold down (B) for at least one
second. Release the button as soon
as the second hand points to “T
(TIME)”.
●
The second hand will move in the
following sequence: “YES” or
“NO” n “T (TIME)”.
●
This indicates that time
information receipt has started.
30
Second hand
Operation Guide 5412
4