Filter
Top Products
3. Press (C).
Confirm that the small hour hand and
small minute hand are stopped at 12
o’clock.
30
Small Minute
Hand
Small Hour
Hand
4. If the small hour hand and small
minute hand are not at 12 o’clock,
rotate the crown to align them
correctly.
5. Press (C).
Confirm that the mode hand is
stopped at 12 o’clock.
30
Mode hand
6. If the mode hand is not at 12 o’clock,
rotate the crown to align it correctly.
7. Press (C).
Confirm that the day indicator shows
1.
1
Day
8. If 1 is not shown for the day, rotate the
crown until 1 is shown.
9. Push the crown back in.
Note
●
Leaving the crown pulled out for
more than approximately 30
minutes without performing any
operation will automatically
cause the adjustment operation
to become disabled. If this
happens, push the crown back
in to its normal position and then
pull it out gain to restart the
procedure from the beginning.
Pushing the crown in to its
normal position part way
through the alignment
procedure will cause the hands
to return to their normal position.
Any alignment you performed
up to that point will be applied.
Moving To Another Time
Zone
Use the procedure below to easily
change day and time settings of the
watch to a destination location.
●
Any time you perform a GPS signal
receive operation, the watch may try to
acquire leap second information. A
leap second information receive
operation can take as long as 13
minutes. Make sure the watch is
sufficiently charged before performing
a GPS signal receive operation after
you arrive at your destination.
●
Prior to Takeoff
1. Enter the watch’s Airplane Mode
when instructed to do so by airline
personnel.
30
Airplane mark
●
After Arriving
1. Exit the Airplane Mode.
2. Perform a GPS signal position
acquisition operation, which will
adjust the watch’s time setting to
your current location.
l Using the Watch on an Aircraft
l Acquiring GPS Position
Information Manually
Other Information
City (Time Zone) List
A time zone for which no city name is
displayed by the watch is indicated in the
table below by a hyphen (-) in the “City
Code” column. The “City Name” column
will contain the name of a representative
city in that zone.
City
code
City Name
Second
Hand
Position
UTC
Offset
UTC
Coordinated
Universal Time
Second 0 0
LON London Second 2 0
PAR Paris Second 4 +1
ATH Athens Second 6 +2
JED Jeddah Second 8 +3
- (Tehran) Second 9 +3.5
DXB Dubai Second 10 +4
- (Kabul) Second 11 +4.5
- (Karachi) Second 12 +5
DEL Delhi Second 13 +5.5
- (Kathmandu) Second 14 +5.75
DAC Dhaka Second 15 +6
- (Yangon) Second 16 +6.5
BKK Bangkok Second 17 +7
HKG Hong Kong Second 19 +8
- (Eucla) Second 21 +8.75
TYO Tokyo Second 22 +9
- (Adelaide) Second 23 +9.5
SYD Sydney Second 24 +10
-
(Lord Howe
Island)
Second 25 +10.5
Operation Guide 5412
10