Filter
Top Products
Operation Guide 4312/4313
7
High-speed Lock
• While holding down the D button to start high-speed clockwise
movement of the hands, press the B button to lock the high-
speed movement.
• High-speed movement of the hands will continue until it completes
a 12-hour cycle, or until you press any button to stop it.
• High-speed hand movement will stop when an alarm or any other
beeper operation is performed. Hand movement will resume after
the beeper operation is complete.
3. When the setting is the way you want, press the
AA
AA
A
button to exit the setting screen.
• This exits the setting screen and synchronizes the minute
hand with the current seconds count automatically.
• The display also will exit the setting screen automatically if you
do not perform any operation for about two or three minutes.
Setting the Analog Time Manually
You can use the Hand Setting Mode to adjust the analog time
manually when it does not match the digital time.
Getting Ready:
Use the
CC
CC
C button to enter the Hand Setting Mode as shown
under “Modes and Display Screens”.
1. Hold down the
AA
AA
A button
for about two seconds
until the hour and
minutes of the digital time
start to flash.
2. Use the
DD
DD
D button to
adjust the analog time.
• Each press of the D button
advances the analog time by
20 seconds.
• Holding down the D button
advances the time setting at
high speed.