Filter
Top Products
Operation Guide 3038
1
MA0609-EA
Reading the Display
The display normally shows the current time and date (in the
Timekeeping Mode).
Button
Button
Day of the Week
Day
Hour
Minute
Second
PM indicator
(A for AM)
Indicator
Button
Button
Days of the Week
SU: Sunday MO: Monday TU: Tuesday
WE: Wednesday TH: Thursday FR: Friday SA: Saturday
● Indicators
• Indicators are not displayed when performing a magic trick.
Button operation tone is off
Alarm is on
Hourly time signal is on
● Toggling between Date Displays
Each press of the D button toggles between the two date displays
shown below.
Day of the Week
Day
Month Day
● Turning the Button Operation Tone On and Off
Perform the following operation to toggle the button operation tone on
(tone sounds when a button is pressed) and off. When any screen
besides a setting screen (one with a flashing setting) is on the display,
hold down the C button for about three seconds.
• This will cause the button operation tone to
sound and then toggle the tone on or off.
• The
is on the display while the operation
tone is off.
• Holding down the C button also changes
the watch’s current mode.
• The watch’s alarm and hourly time signal
will still sound even when the operation tone
is turned off.
Each press of the C button cycles through available modes in the
sequence shown below.
Modes
Alarm ModeStopwatch Mode
The stopwatch performs 1/100 second elapsed time
measurement up to 23 hours, 59 minutes, 59.99 seconds
(24 hours).
This mode lets you configure a daily alarm and an hourly time
signal.
Magic Mode
You can select from among five magic tricks.
Timekeeping Mode
Illumination
Pressing the B button in any mode besides the Magic Mode or while a
setting screen (one with a flashing setting) is on the display will turn on
illumination.
• Illumination provides easy reading in the dark.
Important!
• Illumination may be difficult to see under bright sunlight.
• If you press the B button, or if an alarm or other beeper operation starts
while the face is illuminated, illumination will turn off.
• You may notice a slight sound from the watch while illumination is turned
on. This is the sound of EL panel vibration and does not indicate
malfunction.
Using the Stopwatch
In the Timekeeping Mode, press the C button three times to enter the
Stopwatch Mode.
Minute
Second
1/100 second
About 1 second
Hour
Timekeeping Mode Stopwatch Mode
Stopwatch Mode
• The stopwatch performs 1/100 second elapsed time measurement up to
23 hours, 59 minutes, 59.99 seconds (24 hours). When the maximum
limit is reached, the elapsed time returns to zero automatically and timing
continues from there.
■ Measuring Elapsed Time
In the Stopwatch Mode...
• Each press of the D button starts or stops the stopwatch.
• Pressing the A button while the stopwatch is stopped will reset
stopwatch to all zeros.
Start / Stop
Reset
Stop ResetStart
Cumulative Time Measurement
Pressing the D button to restart the stopwatch without resetting it to all
zeros will resume elapsed time measurement from where it was last
stopped.
Note that instructions do not contain any
information about using the Magic Mode.