Filter
Top Products
Operation Guide 5002 (GMS)
5
Home Position Adjustment
If the time setting of your watch is not correct even though time
calibration signal reception is being performed normally, use
the procedure in this section to check the home positions of
the hands and make adjustments as required.
Note that you do not need to perform the following operation if
your watch is showing the correct time.
,EFTDIAL
HAND
$AYHAND
1.
In the Timekeeping Mode,
hold down the
A
button
and then the
B
button,
keeping both buttons
depressed for about fi ve
seconds until the day hand
and left dial hand move to
their home positions.
Home Positions
Day hand: 31
Left dial hand: 60
•
If the hands are at their proper home positions, advance to step 3.
2.
If the left dial hand
position is off, use
C
to move it clockwise to
correct it.
•
Holding down the
C
button will cause the left
dial hand to move at high
speed.
•
High-speed movement
of the left dial hand
will continue until
it completes a full
revolution, or until you
press any button to stop
it.
(OURANDMINUTEHANDS
,OWERDIALHAND
3.
Press
B
to advance to
home position adjustment
for the hour, minute, and
lower dial hands.
•
This should cause all three
hands to move to their home
positions.
Home Positions
Hour hand: 12 o’clock
Minute hand: 12 o’clock
Lower dial hand: 24 o’clock
•
If the hour, minute, and lower dial hands are all at their proper
home positions, advance to step 5.
4.
If the hour and minute
hand positions are off,
use
C
to move them
clockwise to correct
them.
•
Holding down the
C
button will cause the
hands to move at high
speed.
•
High-speed movement
will continue until it
completes a 24-hour
cycle, or until you press
any button to stop it.
•
The 24-hour time hour
setting of the lower dial
hand is synchronized
with the hour and minute
hands, so separate
adjustment is not
required.
$AYHAND
2IGHT
DIALHAND
)NDICATES
THEDAYOF
THEWEEK
4YPE"RIGHTDIALHAND
5.
Press the
B
button to
advance to home position
adjustment of the day and
right dial hands.
•
This should cause the day
and right dial hands to move
to their home positions.
Home Positions
Day hand: 31
Right dial hand:
▼
(between SU and MO)
•
If the day of the day and right dial hands are at their proper home
positions, advance to step 8.
$AYOFTHE
WEEK
$ATE
6.
If the day hand position
is off, use
C
to move it
clockwise to correct it.
7.
If the right dial hand
position is off, use
A
to move it clockwise
to correct it.
•
Holding down the
C
or
A
button will cause the
hand to move at high
speed.
•
High-speed movement
of the will continue until
the hand completes a full
revolution, or until you
press any button to stop
it.
8.
To exit home position
adjustment and return to
normal timekeeping, press
B
.
•
The watch also will exit
home position adjustment
automatically if you do not
perform any operation for
about two or three minutes.
After completing the home position adjustment procedure,
put the watch in a location where it is able to receive the
time calibration signal easily and perform a manual receive
operation.
•
For information about the manual receive operation, see
“Receiving a Calibration Signal”.