Filter
Top Products
16
Frame Guards
Normal line and cable movement against the
frame can wear away painted nishes and
decals. Overtime, cable rubbing can wear into
the frame itself causing very serious frame
damage.
KF103/
(8 pcs)
To apply the guard material :
1. Clean the frame with a mild detergent and
wipe dry with a clean towel. Do not use
solvents or harsh chemicals to clean the
frame. OPTIONAL: Trim the adhesive guard
material to the shape required.
2. Remove the backing and position the
guard under the cable/ line.
3. Rub the guard rmly against the frame
with your ngers to x it in place.
4. Periodically, recheck the guards and other
areas of the frame as you continue to ride.
Replace the guards if they wear out.
PLEASE NOTE: Damage to your bike caused by
cable rubbing is not a condition covered under
your warranty. Also, adhesive frame guards
are not a x for incorrectly installed or routed
cables or lines. If you nd that applied guards
are wearing out very quickly, consult with your
Cannondale Dealer about the routing on your
bike.
THIS PHOTO SHOWS A TYPICAL USE OF
GUARD MATERIAL AT A CONTACT POINT.
Check over your bike after your
rst few rides. Apply the guard
material where rubbing is found.
When applied correctly, the guards
material is good protection for
your bike.