Filter
Top Products
14
www.cannondownriggers.com
USING YOUR DIGI-TROLL WITH THE INTELLITROLL
ACCESSORY
Both the Digi-Troll 5 and Digi-Troll 10 are compatible
with the IntelliTroll accessory. The Digi-Troll 5 receives
the IntelliTroll data and sends it to your Humminbird
fishfinder (using the Cannonlink accessory). You can
also use the Intellitroll monitor and antenna cable as-
sembly to display sensor information. The Digi-Troll 10
also displays the IntelliTroll information on the internal
LCD display.
To install the Intellitroll on the Digi-Troll follow the below
steps:
1) Locate the antenna mounting bolt in the location
shown. (Figure 20)
2) With a 1/4” wrench, loosen the bolt and remove.
(Figure 21)
3) Install the antenna spring that came with the Intellitroll
sensor kit. Insert bolt into the closed loop on the spring.
(Figure 22)
4) Tighten bolt until tight. (Figure 23)
Caution: Do not over tighten as the stainless steel
bolt head may shear with too much torque.
5) Once the antenna is installed, run downrigger cable
through center of spring. (Figures 24 & 25)
Note: It is recommended that you use the coated
cable that came with your Intellitroll sensor for
proper sensor operation. The use of non-coated
could result in poor display performance and/or a
loss of data signal. Refer to your Intellitroll owners
manual for more detailed instructions.
FIGURE 20
FIGURE 21
FIGURE 22
FIGURE 23
Installation