Bushnell Nov-00 Binoculars User Manual


 
TAKING A PICTURE
With the camera turned on, press the SNAP button to take a new photo. For best results, hold
the
ImageView steady using both hands, and lightly press down the SNAP button using the
flat
end of your finger rather than “punching” it with a fingertip. Be sure you are at least 30
feet
away from your subject as the camera focus is preset for optimum results with distant
objects (ie: sports, wildlife, etc.).
CHANGING
OPERATIONAL MODES
Pressing the MODE button briefly will cycle through several special camera modes and settings.
A
corresponding icon or symbol (indicated in parentheses below) will be displayed on the LCD
for each mode as you cycle through them by tapping the MODE button,
and blink unless you
select or confirm it with the SNAP button (icon will stop blinking). If no button is pressed for
mor
e than 5 seconds, the camera will return to normal operation. The modes/settings are
shown as you cycle through them in the following order:
• T
imer ( ) : selects the self-timer, which will take a photo after a 10 second delay when you
press the SNAP button. This
is useful for avoiding blurry photos from bumping the camera
when it is mounted on a tripod (optional), especially in low light conditions. Once set, the
camera will remain in self timer mode until you return to the timer mode setting and turn
it off.
• R
epeat Shot ( ) : Takes rapid series of 3 consecutive photos, approx. 1 second apart,
when you press and hold the SNAP button. As with the timer, the camera will remain in
Full
Low
Dead
ON
Full
Low
D
ead
022
022
3M
H
M
L
3M
H
M
L
*
**
***
*
**
***
2