Filter
Top Products
Loading Batteries
Inserting An SD Card
Turn the Instant Replay over, and slide open the battery cover as indicated by the
arrow, then tilt it up on its hinges. Insert 2 AAA Alkaline or Lithium batteries into
the compartment in the direction indicated by the diagrams inside, then tilt the
cover down again and slide it back into place until it clicks. Note: Rechargeable
NiMh type batteries may also be used, but some may not deliver adequate current to
power the Instant Replay. AAA NiMh batteries with a current rating of 850 mAh or
higher are recommended.
e camera can store from about 15 (at 5 MP resolution and Best quality) up to over 300 photos in the 16 MB
internal memory, depending on resolution and quality settings (refer to the chart at the back of this manual). To
expand the available storage, you may add an optional SD (Secure Digital) memory card, with 1GB or smaller
capacity (256MB, 512MB etc). MMC cards, which look similar to SD cards, are not recommended. e card
is inserted into the slot on the back of the camera pod, with the “notched” corner on the left as indicated by the
card icon below the slot. Insert the SD card with the label side facing down. Note: be sure the power is turned off
before inserting or removing cards to prevent possible loss of files or damage to the card. A new card will not require
formatting, but a card that has been previously used in other devices (cameras, PDAs, etc) should be formatted by
the Instant Replay before beginning to take photos or videos (see the “Review Menu” section for how to do this).
Note that formatting will erase all files previously stored on the card, so be sure they have been downloaded
or copied first if you wish to keep them.
10
Tripod
Socket
Battery
Compartment
(Slide Open
In Direction
of Arrow)
118325 Compact Instant Replay 6L10 10 6/4/07 12:56:27 PM