Filter
Top Products
During fine mode operation, the LED will alternately flash in orange and green.
Briefly pressing the power button again will switch operation back to normal mode, and the LED will
return to a steady green light.
Stabilization Lever
Setting the stabilization lever back to the HOLD position turns the stabilization feature off, and the
LED turns orange again, indicating Standby mode.
Set the stabilization lever as you wish.
Standby mode conserves battery power.
When finished, turn the stabilization lever to the HOLD position and press the Power button to turn off.
If you leave your Bushnell StableView binoculars in either Standby or Stabilization mode for a few
minutes without using them, the stabilization lever will return to the HOLD position, and the
binoculars will shut off automatically.
Stabilization lever position power button operation Equipment status LED status
HOLD Hold down ON (Standby) Lit/flashing orange
Press briefly, Switches between Alternately flashing
ACTIVE then release
fine and normal green/orange (fine)
for several seconds in modes or steady green
standby mode (normal)
HOLD Hold down OFF OFF
6