Filter
Top Products
6
MOUNTING YOUR FIRST STRIKE REFLEX SIGHT
• Any Weaver or Picatinny style base is suitable for
mounting the First Strike. Make sure the base you
use is manufactured specically for your pistol, rie
or shotgun. Be sure the base is properly installed and
securely fastened according to the manufacturer’s
instructions for your safety.
• There is no set eye relief for this sight, therefore, you
should provide at least three inches of clearance
between the end of the sight and your eye when in
the shooting position.
• Loosen the hex bolt on the mount of the sight (C)
using the large hex wrench (L). Position the mount
on your base rail so that the crossbolt engages a slot.
Tighten the hex bolt.
ZEROING YOUR FIRST STRIKE REFLEX SIGHT
Note: the following should be done at an approved
range or other safe area. Eye and ear protection is
recommended.
The First Strike scope has an integrated photocell
(A),
which automatically activates the unit when the
protective lens cover
(H)
is removed, so there is no power
switch. When you are nished using the scope, simply
replace the cover to turn the power o again. Brightness
of the 5 moa red dot is also automatically regulated by
the photocell, based on the level of ambient light.