Bushnell 70-0002 Watch User Manual


 
WARRANTY / REPAIR
11
TROUBLE SHOOTING
If the Cardinal points (N, NE, E, SE etc.) on your compass blink - Try holding the compass
LEVEL using the bubble level as a guide. The Cardinal points may also blink when the Compass
encounters magnetic interference from the surrounding areas. The Cardinal points blink because
the Compass is unable to measure bearings accurately. If this does not fix the blinking, please
recalibrate your compass. (Go to page 7 for Compass Calibration.) Remember to keep the
Compass away from metal objects which may cause magnetic interference. Double check that
your declination is properly set (In general, zero degrees should be the default setting).
Three dashes are displayed Your compass has gone into a "sleep" mode to save batteries. Press
COMP to reactivate the compass.
Can’t turn unit off This unit is designed to be constantly on and the batteries will last about a
year assuming normal usage.
Reset compass - If, during operation, an external electrodischarge occurs near the compass, the
unit may exhibit erroneous readings. To solve this problem, the watch must be reset and
recalibrated. Note: The watch is automatically reset when the battery is removed.
If your wristtop goes into a test mode after inserting the battery You will need to re-install
your battery. Remove battery. Wait 10 seconds then carefully re-insert the battery making sure
that it is well placed in the battery compartment. Close battery door.
You will know that your wristtop has gone into test mode If you see the LCD segments around
the display turning on one-by-one and moving in an counter-clockwise direction. After the test
mode is completed, your wristtop will return to normal. The test mode will not harm your
wristtop's normal operation.
10
TWO-YEAR LIMITED WARRANTY
Your Bushnell® product is warranted to be free of defects in materials and workmanship
for two years after the date of purchase. In the event of a defect under this warranty, we
will, at our option, repair or replace the product, provided that you return the product
postage prepaid. This warranty does not cover damages caused by misuse, improper
handling, installation, or maintenance provided by someone other than a Bushnell
Authorized Service Department.
Any return made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $10.00 to cover the
cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent
damage in transit, with return postage prepaid to the address listed below:
IN U.S.A. SEND TO: IN CANADA SEND TO:
Bushnell Performance Optics Bushnell Performance Optics
Attn.: Repairs Attn.: Repairs
8500 Marshall Drive 25A East Pearce Street, Unit 1
Lenexa, Kansas 66214 Richmond Hill, Ontario L4B 2M9
For products purchased outside the United States or Canada please contact your local dealer
for applicable warranty information. In Europe you may also contact Bushnell at:
BUSHNELL Performance Optics Gmbh
European Service Centre
MORSESTRASSE 4
D- 50769 KÖLN
GERMANY
Tél: +49 (0) 221 709 939 3
Fax: +49 (0) 221 709 939 8
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2003 Bushnell Performance Optics