Filter
Top Products
6
Do not store this device while the indicator is lit.
This device can be mounted on any tripod with a ¼” tripod socket.
Caution: This device can be used in extreme cold weather. However, when the unit is brought back
into a warm environment, you must wait approximately 5 hours before using the unit again. Damage
may occur due to condensation that may have accumulated on the internal circuitry of the unit.
SPOTS IN THE IMAGE
You may see spots in the image. These vary from device to device and are cosmetic blemishes inside
the device. These are normal for Night Vision devices and are NOT a defect.
TROUBLESHOOTING
Scope will not turn on.
Check that the batteries are installed properly. Replace the batteries with new ones. Check the battery
contacts to ensure it is clean and free of corrosion. Check that the power is in the “ON” position.
Image is not focused.
Adjust the focus on the Eyepiece (5). Adjust the Objective Lens (1).
If still no improvement, clean the lenses; they may be foggy or dusty.
Visibility decreases or disappears.
Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn
the Power OFF (2) and turn the scope away from the light source. The unit will restore itself in 1 or 2
minutes. Conditions such as fog or extremely dark environments will decrease visibility.