Bushnell 26-0400 Binoculars User Manual


  Open as PDF
of 52
 
6
Caution: This device can be used in extreme cold weather. However, when the unit is brought back into a warm
environment, you must wait approximately 5 hours before using the unit again. Damage may occur due to
condensation that may have accumulated on the internal circuitry of the unit.
Spots In The Image
•Youmayseespotsintheimage.Thesevaryfromdevicetodeviceandarecosmeticblemishesinsidethedevice.These
arenormalforNightVisiondevicesandareNOTadefect.
TROUBLESHOOTING
Scope will not turn on.
Checkthatthebatteriesareinstalledproperly.Replacethebatterieswithnewones.Checkthebatterycontactstoensure
theyarecleanandfreeofcorrosion.Checkthatthepowerisinthe“ON”position.
Image is not focused.
AdjustthefocusontheEyepieces.AdjusttheObjectiveLenses.Ifstillnoimprovement,cleanthelenses;theymaybe
foggy or dusty.
Visibility decreases or disappears.
Brightlightsourcessuchasheadlightsmaycausevisibilitytodegradeordisappearcompletely.TurnthePowerOFF
and turn the scope away from the light source. The unit will restore itself in 1 or 2 minutes. Conditions such as fog or
extremely dark environments will decrease visibility.
Scope flashes.
The scope may flash when used in a bright environment. It may also flash during the first few seconds of use in dark
environments.
 previous next