Bushnell 26-0400 Binoculars User Manual


  Open as PDF
of 52
 
4
GETTING STARTED
Installing Batteries
This device operates on two AA batteries. To install, unscrew the
battery compartment cover located on the bottom of the unit. Insert the
batteries into the battery compartment so that the (+) and negative (-)
terminals of the batteries match the markings inside the compartment.
Replacethebatterycovercarefully–donotovertighten.
Use and Testing
ThisdeviceoperatesontwoAAbatteries.Makesuretheyhavebeen
installed according to the instructions above.
If you wish to test your night vision device in a lighted area, be sure
the objective lens cap is covering the objective lens prior to pressing
the“POWER”button.Theobjectivelenscaphasapinholeopening
to admit a small amount of light for testing purposes.
If testing or using the device in the dark, remove the objective lens cap
andactivatethedevicebypushingthe“ON”button.
To focus, select an object at the approximate distance for the area
thatyouintendtoview.Settheadjustingmarkontopofthefront
(objective)lensesagainsttheletter“N”ontheword“Normal”.Adjust
eacheyepiecedioptersettinguntiltheimageisinfocus.Afteryour
initial diopter setting, the front (objective) lenses are now utilized for
focusing: adjust the front lenses clockwise when you need to focus on
closer objects, counter clockwise for more distant objects. If you are
unable to focus on very close objects, the eyepieces may then be used
for micro adjustments only.
 previous next