Bushnell 20-4124EU Hunting Equipment User Manual


 
19 20
maximum distance needed. Measure the bullet drop at each distance and then convert the drop into moa.
Multiply the moa by 4. Using this number, count the number of tick marks on the dial and mark the distance.
Example: Suppose you have a bullet drop of 9 inches at 300 yds. This is a drop of 3 moa. Since the
clicks are ¼ moa, the drop for 300 yds would be 12 tick marks.
USING MIL DOTS
Your new Bushnell
®
YARDAGE PRO
®
LASER RANGEFINDER RIFLESCOPE contains a mil-dot
reticle. Since the riflescope already contains an integrated laser rangefinder, it is not likely that you will
If Bullet Drop is: @300 yds @300 m @500 yds @500 m
Use:
A 25-31 inches 63-79 cm 114-146 inches 291-370 cm
B 20-25 inches 50-63 cm 88-114 inches 225-291 cm
C 16-20 inches 40-50 cm 72-88 inches 182-225 cm
D 13-16 inches 34-40 cm 61-72 inches 155-182 cm
E 12-13 inches 30-34 cm 55-61 inches 139-155 cm
F 10-12 inches 25-30 cm 47-55 inches 119-139 cm
G 8-10 inches 20-25 cm 39-47 inches 99-119 cm
H Less than 8 inches Less than 20 cm Less than 39 inches Less than 99 cm
need the mil dot for measuring distance, but is useful for precise leads for moving targets and exact
compensation for shooting in a crosswind. There are certain situations that may not allow one enough
time to range to an animal, and having the mil-dot reticle is second alternative in measuring distance.
The middle of this reticle contains four evenly spaced mil-dots arrayed outward vertically and
horizontally from the center. Actually, because the very center dot was left out to allow clear aiming, the
reticle represents five mils in any direction.
One mil is the space from center-dot to center-dot. One-half and one-quarter mils are easy to estimate
mentally; with practice, you can measure tenths of mils for the most exact ranging.
RANGING WITH YOUR MIL-DOT RETICLE
The mil is an angular measurement— a milliradian—which equals almost precisely one yard at 1000
yards, or one meter at 1000 meters. This proportional relationship makes possible a simple formula to
compute distances:
The Measured Object’s Width Or Height In Yards x 1000
= Range In Yards
Object’s Width Or Height In Mils
This formula works equally well with meters, but don’t mix meters and yards: Measure the object in yards
to find the distance in yards, use meters to yield distances in meters.