Filter
Top Products
QUICK REFERENCE GUIDE
1) Load two AA alkaline batteries into the compartment on the handstrap.
2) Press the Power button (a) to turn on. The electronic system will start up, and the binoculars will go
to S
tandby mode after about five seconds. (LED indicator stops blinking
3) Adjust the eyepiece spacing (b) to match the distance between your two eyes.
4) Use your left eye as you adjust the focus control knob (c). When the image becomes sharp, use your
r
ight eye and turn the diopter adjustment ring (d) to focus for the right eye. Once you have performed
the diopter correction, use only the control knob (c) to check focus again.
5)
Turn the stabilization lever (e) to the ACTIVE position to activate the stabilization feature.
6) Press the power button briefly to change to fine mode, which is more effective at countering hand
shake. Tap the power button again to return to normal mode.
7) When finished, turn the stabilization lever (e) to the HOLD position and press the Power button (a)
to turn off.
LED Status
Lit in orange Standby (stabilization off)
Li
t in green Stabilization active (normal)
Flashing in orange/green Fine mode
Lit in red Batteries should be replaced
Flashing in red System problem
Off Power Off