Bushnell 11-1210 Binoculars User Manual


 
photo storage capacity remaining. Setting the resolution to High will produce better quality photos,
setting the resolution to Low will allow you to store more photos (of lower quality) in the memory
before you stop to download.
• High/Low Quality ( LQ ) : This also affects the amount of space each photo takes up in the memory
by changing the degree of file compression that is used. The default is high quality, pressing
SNAP
when the high quality icon (six dots stacked) is displayed will change the setting to low quality (sixteen
dots stacked). Repeat the procedure to return to high quality again. As with resolution above, the
counter will reflect the increased or decreased photo storage remaining. Refer to the table below to see
how the resolution and quality settings affect the maximum photo capacity. Note: The actual number
of photos the memory will hold may vary slightly, based on subject detail, lighting, etc.
• Power Frequency Setting: (60/50 Hz): This sets the correct electrical frequency to avoid any
“flickering” in the camera’s output. The normal default is 60 Hz (cycles), as used in the United States.
If you are using the camera in a country with 50 Hz power frequency, press
SNAP when “60” is
displayed to change it to “50”.
5
RESOLUTION QUALITY MAX. PHOTOS
High (640x480) High 48
High (640x480) Low 98
Low (320x240) High 186
Low (320x240) Low
374
11-1210 1LIM.indd 9 11/17/04 9:31:24 AM