Filter
Top Products
7
Basic Binocular and Camera Setup
Before you begin using it, you’ll probably want to take a few moments to set up the ImageView for your
individual eyesight and user preferences. Leave the rubber eyecups in their “up” position if you are not
wearing glasses, or roll them down if you are. Grasp the left and right sides of the binocular, and pull them
apart or push them together while looking through the binocular to adjust the eyepiece spacing until your
view is a single circular image. Find a distant object with ne detail (tree, sign, brick wall, etc), and adjust the
center focus knob until the object appears sharp when viewed through the left binocular eyepiece only. Then,
looking at the same object through just the right side of the binocular, simply rotate the right eyepiece until
the image is equally sharp for your right eye. This is called the diopter adjustment, and compensates for any
dierence in sight between your left and right eyes. Once set during this initial procedure, you can leave the
diopter adjustment alone and just use the center focus knob to bring objects at any distance into sharp focus
through the binoculars (the minimum focus distance is about 15 feet).
Your digital photos and videos are not aected by the center focus knob, as the camera lens located
between the binocular’s objective lenses does not require focusing. It is preset so that objects ranging from
approximately 50 feet and farther away will be in focus. Note that the binocular is capable of focusing closer
than the camera. Check the live preview image on the LCD display to make sure you are far enough away to
ensure sharp photos. The camera lens provides 8x magnication, which is the same as the binocular’s optics,
and is aligned so that and object centered in the binocular’s view will also be centered in your photos or
videos. Therefore, it is not necessary to have the LCD turned on or even raised while you are shooting photos
or videos. Reducing use of the LCD will extend battery life signicantly. Pressing the Display button will turn
the LCD screen o but leave the camera powered on, ready to take photos anytime you press SNAP.
You may want to go into the camera’s main menu and set the correct date before using the camera for the rst
time, since the date stamp (imprint) feature is turned on by default (but can be defeated if you wish). Please
refer to Step 4 under “Basic Setup” for details.