Filter
Top Products
4
Burley Cub Owner’s Instruction and Safety Manual
Once the wheels are fully seated in the hollow axle,
the quick-relase lever should be positioned so that it is
aimed to the rear of the trailer in the “CLOSED” position
(the lever is marked for OPEN or CLOSED positions).
The wheel quick-release/axle assembly comes pread-
justed from Burley.
NOTE: All wheels, including optional spoked alloy wheels, must
be mounted with the recessed side of the hub facing out-
ward.
Make sure wheels are held securely, with wheel shaft fully
inserted into the hollow axle. You should not be able to rock or
shift wheels. Improperly installed wheels can fall off, causing an
accident or serious injury.
With wheels mounted, both refl ectors must face outward.
Check to see that both refl ectors have been installed correctly.
Incorrectly installed refl ectors can reduce visibility at night and
cause an accident or serious injury.
III. Installing the Tongue & Safety Flag
Installing the Tongue
The tongue attaches to the left side of the trailer. When installed, the tongue bends
to the right, which places the hitch near the center line of the trailer. Slide the
tongue through the two plastic tongue receptacles until the end of the
tongue is fl ush with the back edge of the rear tongue receptacle.
Secure the tongue as follows:
1. Slide the retaining pin
in the rearward receptacle through
the hole provided in the tongue.