Filter
Top Products
10
Burley Cub Owner’s Instruction and Safety Manual
The straps and sliding buckles sewn to the backrest of the child seat are part
of a self-ad just ing sys tem that keeps the shoulder straps at the correct height
for children of various sizes. When you tighten the shoulder har ness, the sliding
buckles allow the shoulder belts to come across the top of the child’s shoulders,
cre at ing a snug fi t. In addition, the sliding buckles keep the straps from falling
off of the shoulders.
IMPORTANT: Always fasten and adjust the two buckles behind
the child seat when using the trailer.
Single Passenger:
1. Remove both shoulder harnesses from the
shoulder straps (see Section VI for details
on removing the shoulder harness). Unclip
the Y-buckle if necessary. Store one of the
shoulder harnesses in a safe place. Leave
outboard shoulder straps dangling. Do not
unthread the straps from the ladder locks in
this step.
2. Remove the two center shoulder straps by
unthreading them from the ladder locks.
3. Trade the position of the shoulder straps
and re-insert the straps into the ladder locks
as shown in the illustration. The fl at parts of
the male portion of the Y-buckle should face
toward the center.
4. Install one shoulder harness assembly in the
center position as shown
below. See Section VI for details on installing
the shoulder harness.
5. Seat the child in the center of the seat.
6. Snap in the shoulder straps at the Y-buckle.
Ensure that the Y-buckle is adjusted so that it
is at the child’s sternum.
7. Ensure that the shoulder straps are adjusted
so that the child is comfortably kept from
moving too far forward in the seat.
8. Fasten and adjust lap belt so that it is snug.
Ladder Lock