Filter
Top Products
23
Bowex
®
TreadClimber
®
Owner’s Manual
Assembly Guide
Step 16: AFFIX TreadClimber
®
DECALS
Locate the following for this step:
PARTS:
• TreadClimber
®
Base & Treadle Assembly from
Step 15.
HARDWARE:
• Two (2) Treadle Decals
• Two (2) Drive Cover Decals
16-1 There are four places on the Bowflex
®
TreadClimber
®
exercise machine where you
will need to affix the enclosed TreadClimber
®
Decals (see Figure 16-1 and Illustration 16-
A). Clean the application surface with a wet
cloth and dry thoroughly before affixing decal.
Position the decal above the application
surface to center it before removing from the
sticky backing and pressing onto the base
surface.
16-2 Gently wipe the affixed decal with your hand
or a cloth to remove air bubbles.
Step 17: INSPECTING ASSEMBLY
17-1 Now that you have assembled your Bowflex
®
TreadClimber
®
exercise machine, it is VERY
IMPORTANT to tighten all screws and bolts
and visually inspect the TreadClimber
®
machine. Make sure that your TreadClimber
®
machine has been assembled correctly
and securely, and that there are no loose,
uncovered or unattached parts prior to use.
Step 18 – ATTACHING THE POWER CORD
18-1 Make sure that the Main Power Switch is
in the ‘Off’ position, then carefully insert the
power cord into the Incoming Power Plug at
the rear of the base unit (Figure 18-1). Always
plug into the base before plugging into the
wall outlet.
NOTE: Your TreadClimber
®
machine plugs
into any standard grounded (three-
prong) wall outlet and feeds into an
incoming power plug on the back
of the base. NEVER remove the
grounding prong from the power plug
and never use a two-prong adapter
without grounding wire!
Failure to visually check and test assembly
before use can cause damage to the
TreadClimber® machine and serious injury
to users and bystanders and can also
compromise the effectiveness of your
exercise program.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
Figure 18-1
Incoming Power Plug Main Power Switch
Illustration 16-A:
TreadClimber
®
Drive and
Treadle Decals
Treadle decal
1 per side
Drive decal
1 per side
Figure 16-1