Filter
Top Products
29
Sight Set
Assembly
The rear sight is pushed onto the rail of 11
mm width and fixed with the 2 screws (tighten
manually).
Vertical and horizontal adjustment
The screws for vertical and horizontal
adjustment have clicks. The impact point
changes from click to click.
• Shots are too high:
Turn knob into „H“ direction.
• Shots are too low:
Turn knob into „T“ direction.
• Shots are too far at the right:
Turn knob into „R“ direction.
• Shots are too far at the left:
Turn knob into „L“ direction.
Zeroing
After test firing of the rifle both screws should
be brought into the „0“ position.
• Loosen threaded pins in the knob.
• Bring knobs into the „0“ position.
• Tighten threaded pins in the knob manually.
Cleaning and care
Your ANSCHÜTZ rear sight is a highly
accurate device of utmost quality and
therefore needs special handling. Good care
and maintenance guarantee perfect
functionning. Protect your rear sight from dust
and dirt. Guides and spindles must not be
oiled or greased.
Attention:
Your ANSCHÜTZ rear sight has been
adjusted carefully and without play with the
help of special tools. It has been checked
several times and therefore does not require
any additional adjustments. Therefore only
operate the screws for vertical and horizon-
tal adjustments as described above. Do not
turn the screws beyond their stop as this would
cause a permanent damage to the screw
and thread. In order not to endanger your
right of warranty, please contact your dealer
or our repair service in case any malfunctions
might occur.
Front sight
The front sight 6832 combines the
advantages of several sighting aids in only
one small and light device.
Exchange of inserts:
Loosen the rear knurled screw until the slot
opens. Grip the insert at the two studs and
pull it backwards to remove it. When inserting
another insert be aware that the different sizes
of the studs fit into the corresponding gaps.
For plastic apertures we reccomend the use
of our clamping screw 6822-12, Order No.
700.1320.
Cleaning, Maintenance, Care,
Lubrication
Even after considerable use, your
ANSCHÜTZ rifle will not require much
attention - a tribute to its solid design, first class
materials, well proven ANSCHÜTZ
workmanship and precision. All mechanic
components, however, are subject to a
certain kind of wear as all technically
demanding products. ANSCHÜTZ therefore
recommends an annual check-up to find out
whether any repair or adjustment works are
necessary. Regular care and maintenance,
however, does not replace repair works
which must be carried out immediately in the
case of any defects, malfunctions or sudden
safety problems.
If you follow the recommendations below, you
will help maintain the excellent performance
of your rifle for a long time.
Regular care after every shooting
• Please only use resin and acid free oils
(no salad or cooking oils). We recommend
our special grease 4425 (Order No.
710.6310)
• Clean the cone of the barrel and all steel
parts with a slightly oiled, lint-free cloth to
avoid corrosion which might occur as a
result of humid hands or condensed water.
• To avoid corrosion you also should clean
your barrel with a slightly oiled, lint-free
cloth or cleaning cords pulling them
through the barrel from the chamber to the
muzzle. Please use no other means
for cleaning especially no felt pellets and
grease.
• Remove the oil film with a dry cloth or
cleaning cords before you shoot again.
Careful cleaning after approx. 2,000
to 3,000 shots
• The barrel is cleaned with a brass brush
form the chamber to the muzzle (in
shooting direction. Never move the brush