Filter
Top Products
24
Before first shooting
•Wipe away excess oil from the surface
of the barreled action and the rifle.
•Pull a cleaning patch through the barrel
from the chamber towards the muzzle
several times.
Cocking, loading and safety
operation
•Degrease the bolt and the interior of the
barrel without leaving lint.
•Open the reinserted bolt and pull it back
to the stop.
•Now push the bolt forward to close the
breech. A cartridge from the magazine
is fed into the chamber of the barrel. Now
push the bolt handle completely down-
wards. The bolt is now cocked, the rifle is
ready for shooting.
•After firing, lift the bolt handle and pull
the bolt fully to the rear. This will cock
the bolt again and eject the empty case.
The lateral safety can be operated in
cocked condition.
The rifle is
•safe when the red dot on the receiver is
covered (fig. 1).
•ready for shooting when the red dot on
the receiver is visible (fig. 2).
Please note:
The safety lever must latch properly in one
of the two positions. The lever must never
be situated between the two. When the
safety wing is actuated, the trigger must not
be touched. The trigger must not be
released either when the safety wing is in
the „safe“ position.
Safety:
The safety at the receiver locks the trigger.
With regard to safety aspects the safety
advertently is hard to move. Nevertheless,
the bolt can be opened also in the “safe“
position, for example to remove a cartridge
from the case.
You can only operate the safety lever when
the bolt is cocked.
fig.1
fig.2
➡
➡