Filter
Top Products
25
Unloading
For safety reasons the rifle must immediately
be unloaded if you intend to stop shooting.
Remove the magazine and open the bolt.
This will eject the cartridge. Please also see
safety instructions for the handling of rifles
and firearms.
Magazine
•Remove the magazine from the magazine
well.
•Push the cartridges with the head first into
the magazine.
•Push the magazine into the magazine well
until you hear that the magazine holder
has caught the magazine.
•Now open the bolt completely, push it
forward and lock it. Thus the first cartridge
of the magazine is fed into the barrel, the
firing pin is cocked. The rifle is now ready
for shooting.
Bolt
The ANSCHÜTZ bolt
The ANSCHÜTZ bolt is designed to be ex-
tra strong and reliable and is manufactured
to the closest tolerances. Bolt and came are
lapped to assure very smooth operation.
To disassemble the bolt
•Disengage the trigger by pulling the safety
forward.
•Pull the trigger guard and simultaneously
press the left lever (for right hand
versions) forward.
•Let the trigger guard go and remove the
bolt over the released lock.
To re-assemble the bolt
Follow the disassembly procedure in
reverse order. Make sure when inserting the
bolt that the pin on the bolt head is in line
with the groove of the chamber.
Trigger
The trigger has been pre-set by the factory
in an optimum way and guarantees utmost
safety.
Warning:
Your ANSCHÜTZ trigger offers you a
variety of individual adjustment possibilities.
Please note that your rifle always must be
unloaded when any adjustment is carried
out.
Please see the adjusting range for the
referring model from the trigger chart. It
might be necessary to remove the stock from
the barreled action for adjustments at the
trigger.
Trigger adjustments must only be carried
out by an authorized gunsmith.
Modifications at factory-set triggers might
cause severe injuries or death.
Please also see the chapter „General Hand-
ling of Rifles and firearms“.