Filter
Top Products
3
gence not more than 3mm. High of optical axe of the PS-22 under weaver rail is 49mm with
A.R.M.S.#19 ACOG.
6. Tighten the fixing screws or levers of mount.
NOTE: Fixing screws may need to be tightened after continuous shooting.
CONTROL
To turn the device on, rotate the Operation Switch from the OFF posi-
tion to the desired operation mode.
Operation Switch has following positions/modes:
OFF - the device is off;
ON – the device is on;
STB - the device can be used with the Remote Control.
FOCUSING
To focus the scope you need to adjust the diopter first. Simply turn the diopter clockwise until it
stops. Then concentrate on any object and slowly turn the diopter back
counter clockwise until the grain in the image is sharp.
You scope has ability to focus either long range or short.
Focus the front lens by rotating the knob until the image and the grain
are both sharp. When you are in the low-light conditions and the day-
light filter is off you may focus the front lens to receive a sharp image,
the diopter should not be adjusted.
NOTE: The front lens should be readjusted for viewing objects at different distances.
AUTOMATIC BRIGHTNESS CONTROL SYSTEM
The device has a built in Automatic brightness control. This control automatically adjusts the
brightness of Image Intensifier Tube to the optimal level.
PROTECTIVE SYSTEM
The automatic highlight protective system analyzes light expo-
sure with the sensor . If the level of light exposure exceeds al-
lowable the red indicator will lights on. If high light exposure is
kept more than 10 seconds the device automatically will off.
NOTE: The automatic highlight protective system and automat-
ic brightness control system do not protect a sight from damage
by bright light sources (a fire, headlights of the automobile, lan-
terns, etc.). Do not point the device at a bright light source.
IR ILLUMINATION
Infra-red (IR) Illuminators are common for night vision technology. The IR light greatly
enhances the performance of your scope, while remaining almost totally invisible to the naked
eye. In dark environment, power up the scope. Now, find a scene and examine it without the IR
on then with IR powered up. Note the difference in illumination. It is important to remember that
IR Brightness
Adjustment
Battery
Housing
Fixation
Screw
IR Elevation
IR Windage
IR Focusing
Nut
Focus adjustment knob
Sensor