Filter
Top Products
4.) Moisten the transmitter electrodes. For best results, the belt should be worn directly on your skin.
A small amount of moisture is needed to assist in conducting the electrical impulses generated from
your heart beats to the transmitter. Gently pull belt away from skin and
apply a small drop of water or saline solution to each of the two electrodes (one on each side) (Fig.
3).
If you prefer to wear your belt over a light shirt you will need to generously moisten the areas of the
shirt directly beneath the electrodes in order to insure proper signal pick-up. You may wear as many
layers of clothing as desired over the transmitter belt without effecting the operating range.
5.) Put your wrist monitor on. The watch doesn’t have to be attached to your wrist to register your
heart rate it just has to be within 3 feet of your chest.
Exercising with your Basix
plus
6.) Heart Rate -From Time of Day mode click MODE button once to go to Heart Rate mode and begin
your exercise. If your transmitter is correctly attached, the running man indicator on the watch display
should begin to blink and your current heart rate in beats per minute will come up on the display. If
no heart rate is detected for 5 min. the heart rate circuit will switch itself off. The “
” indicator tells if
the heart rate circuit is on. To switch it back on after it has shut off, simply restart the Heart Rate mode
by clicking the MODE button.
7.) The Target Zone -Your watch will provide both a visual indicator (by flashing the heart rate digits)
and an audible alarm (beeping) if your heart rate is above or below your set target zone range. The
”TZ” indicator with the “
” or “ ” will indicate if your heart rate is within, above or below the
set target zone, respectively. Press and hold the ALARM button to turn the beeping alarm on or off
(indicated by the “
“ on the display).
8 .) The Stopwatch -From the Heart Rate mode simply press the START/STOP button to activate the
stopwatch. You can pause and restart by pressing the START/STOP button. You can also press the
MODE button to view
the Recall or Time modes without interupting the stopwatch. When you have finished, simply press the
STOP button to end the recording. Press the MODE button to proceed to the Recall or Time mode.
*Quick Start -This feature instantly takes you to the Heart Rate/Stopwatch mode and starts or
stops the stopwatch and recordings from any mode, at one simple press of the START/STOP
button.
9 .) Nite-Site night light operation - simply press
the LIGHT button once to light the display for 3 seconds.
10 .) Smart-Light between the hours of 6 PM & 6AM any button press will activate the night light for
2 seconds.
Page 9 of 13
Electrodes