Filter
Top Products
The header consisting of the date/time stamp will be shown. The number of laps in the segment will appear
in the upper left while the segment number is displayed in the middle left. If the segment shown is not your
desired segment, press [START] to reach the desired segment. The current segment will be accessed first,
then it will cycle back to the 1st, then 2nd and so on.
When you have found the segment you want, you can press [RECALL] button consecutively to read the lap
records from the first to the last lap.
As you continue to press [RECALL] during the display of the last lap, you can advance to the next segment by
pressing [START], The front page of the segment will be shown. Say the next segment is SEG 1.
How to delete individual memory segments:-
Search the desired segment first as described above. During the display of the segment front page, press
[RESET] for 2 seconds to activate Delete One function. "DELETE ONE" will be shown in blinking and beep
sound will be generated.
A "ready" period of 2 seconds will be counted. At the end of the ready period, all the lap records of the
corresponding segment will be erased. And a long beep sound will be heard. Then the display will show the
next segment. If you don't want to delete the records, you can press any key to exit from delete ready state
before the end of the ready period and resume the display of the segment front page.
0: 01' 00" 55
0: 00' 12" 86
0: 01' 00" 55
SPLIT
LAP
RUN
{001}
RECALL
{002}
SEG
2 0 0 1
2 - 1 8
A 10: 00' 15
{012}
RECALL
{001}
SEG
dELETE
OnE
11