V300 Quick Start Guide
5
1 Press the navigator up or down to access the
menu, and scroll down to Adv Setting. Press
Menu.
" You can also use the alphanumeric keypad to make your selections in the
LCD screen. For example, you can press the 6 key in the Menu Setting
screen (above) to go to the Adv Setting screen.
2 Select Network (press 1).
Choose from the following options:
• If you were given a username and password for
network access, go to section 2.1.1 on page 5.
• If you were given an IP address and subnet mask to use, go to section 2.1.2 on page 6.
• If you were not given an IP address to use, go to section 2.1.3 on page 7.
2.1.1 Set Up PPPoE
1 If you were given a username and password,
press 1 in the Adv Setting > Network menu.
2 Select Active (press 1).
3 Press Menu and continue to step 4.
4 Press Menu to enable PPPoE.
5 The PPPoE menu displays again. Scroll down
to Username (press 2).
Menu Setting:
5 Adv Setting
5 Adv Setting:
1 Network
1 Network:
1 PPPoE
1 PPPoE:
1 Active
1 Active:
Disable
1 Active:
Enable?
1 PPPoE:
2 Username
