IES-1000 User’s Guide
11-8 ADSL Module Port Setup
When auto-negotiation is turned on, the Ethernet port of the IES-1000 negotiates with the peer Ethernet port on
the Ethernet cable automatically to determine the optimal connection speed and duplex mode. If the peer Ethernet
port does not support auto-negotiation or turns off this feature, the IES-1000 determines the connection speed by
detecting the signal on the cable and using half duplex mode. When the IES-1000’s auto-negotiation is turned off,
the Ethernet port uses the pre-configured speed and duplex mode settings when making a connection, thus
requiring you to check the settings of the peer Ethernet port in order to connect.
11.9.1 Ethernet Port Setup Screen
Click 0 in the Port Setup screen to open this screen.
Figure 11-4 Ethernet Port Setup
The following table describes this screen.
Table 11-5 Ethernet Port Setup
LABEL DESCRIPTION
Port Setup Click this link to go to the Port Setup screen.
Mode Use the drop-down list box to select a speed and duplex setting for the Ethernet port. In
10/100Mbps Fast Ethernet, the speed can be 10Mbps or 100Mbps. The duplex mode can be
Half (meaning traffic is transmitted in one direction at a time) or Full (meaning traffic is
simultaneously transmitted in both directions). Select Auto to have the Ethernet port auto-
negotiate with a peer to obtain the connection speed and duplex mode.
Default 802.1p
Priority
Type the priority value (0 to 7) to add to incoming frames without a (802.1p) priority tag.
